Application

How to apply our DIY lashes

Before you start applying, please ensure lashes are free of any oil residue, make up or mascara.

Please ensure to pick up your DIY lashes using your applicator from the lash line, as they are very delicate and lightweight. 


Step 1: BOND

Apply a layer of the bond to the roots of the lashes, brushing upwards. Less is more. You can also apply the bond directly to the DIY lash and then apply straight onto your natural lash.

Step 2: LASH

Apply each lash individually under your natural lash line and repeat. Be sure to not apply the lashes to your waterline. Lashes can be layered for a more glamorous look. 

Step 3: SQUEEZE
Use the lash applicator to pinch the DIY lashes and your natural lashes together. A tip to prevent the glue from sticking to the applicator, is too apply a small amount of sealant on the applicator before you squeeze your lashes together. 

Squeeze lashes in sections for around 10 seconds at a time to secure and lock them in.

Step 4: SEAL
Once you have applied all your lashes, apply the sealer to the roots of the lashes where the bond was applied. This will remove any sticky residue and extend the wear time.